User guide P9-0158-B
26 of 48
Version 1.0.2/2011
Medema Production A/S
Avoid draining the batteries completely. We recommend
charging the batteries in a heated room. If it is not possible to
do this every day, it is a good idea to charge the Mini Crosser in
a heated room (approx. 20°C) once a week.
New batteries do not reach full capacity until they have been
charged and discharged about 20 times.
It is IMPORTANT to fi t the batteries correctly. The battery terminals
and snap locks are /-. They must be fi tted as shown in the
sketch below. Make sure that the snap locks are properly closed.
For the same reason there must not be any burrs on the terminals.
The Mini Crosser should be charged while not in use. The
charger supplied from the factory switches over to trickle
charging (very low power consumption) automatically when the
batteries are fully charged. You can therefore leave the charger
connected until the Mini Crosser is next used. The charger
cannot overcharge the batteries.
The charger will fl ash until charging is complete. Then it will
show a steady light.
The charger must not be placed on the seat during charging.
IMPORTANT! Never use charging devices other than those
supplied from the factory without fi rst contacting the dealer.
NEUTRIK NC3MX charging plug
Connect the charging plug to the 3-pin
socket on the joystick.
Summary of Contents for Mini Crosser M joy
Page 48: ...medemagroup...