Setup
7
A.
As shown below, firstly four turned back nuts of the pedal should be
used to stuff the corresponding holes. And then both the left and the
right feet should be connected to each side of the pedal,
respectively. In the next step, the Phillips screws should be aligned
with the tuned nuts through the feet screw holes, tightened with a
screwdriver and finally covered by a plastic screw cap.
(Make sure the devices in the right direction before installing.)
B.
As shown below, align the holes on the piano body and tighten them
to install the piano body on its feet.
Turned nut (4PCS)
Phillip s head screws M6x50 (4PCS)
Plastic screw cap (4PCS)
Plastic screw cap (4PCS)
Phillips head screws M6x50 (4PCS)
Gasket (2PCS)
Screw M4x15 (2PCS)
Sound box cables
C.
After the installation ,the foot pedal cable,the host box hole and
the corresponding sound box cables are inserted into the piano
through the bottom of the body and then connected to the
power. Especially, either the left or the right sound box cable is
inserted into the socket at the bottom of the piano body.
0
5
25
75
95
100
AW_CDP5200_Manual_G09_140718
2014
7
18
17:19:12
