MED ASSOCIATES, INC.
PHM-104A HIGH/LOW SPEED PRECISION PUMP
28-V Output Via MED-PC
This section describes the procedure for using a MED-PC 28-Volt output to turn the pump on and off.
The pump will operate using the default parameters.
1.
Using the 24 VDC power supply connect the
24 VOLTS
connector on the PHM-104A to a standard
wall outlet.
2.
Turn the PHM-104A on using the green ON/OFF switch.
3.
Set the pump’s default parameters using the pump control application described in Figure 3.4 -
PHM-104A Control Software Screen.
4.
Connect the
MED OPERATE
port (Figure 2.3) on the pump to any available output on a standard
MED Connection Panel (e.g. SG-716D), using the included cable.
NOTE: Be sure that the USB cable is NOT connected to the pump, as the MED OPERATE port will not
be recognized if it is.
5.
Set the FLUSH/REMOTE/TEST switch to
REMOTE
. The pump will now execute a complete infusion
using the default parameters each time it receives a 28-Volt output pulse from MED-PC.
- 15 -
DOC-187 Rev. 1.6 Copyright © 2019
Med Associates, Inc.