14
LP Hose and Regulator
To reduce the risk of serious bodily injury or death
from fire or explosion:
• Clean and inspect the gas hose/regulator before
each use of the outdoor cooking gas appliance.
The gas hose/regulator must be replaced prior to
being used, if there is evidence of excessive abra-
sion or wear, or if the hose is cut or leaks.
• Use only the gas hose/regulator assembly that
has been supplied with this gas grill. Do not
use hose/regulator from another manufacturer.
Replacement gas hose/regulator assembly must be
specified by this grill’s manufactuer before using.
• Always check for gas leaks when you connect
and disconnect the hose/regulator to the LP Gas
Cylinder, especially after a period of storage (for
example, over winter).
• Make sure there are no sharp bends in the hose.
• Make sure the hose/regulator does not contact any
heated surfaces.
WARNING
!
NOTE:
If the hose/regulator assembly is not working properly
and you need a replacement, contact
Customer Service
at 1-800-251-7558
or go to
www.aussiegrills.com
.
Be sure to
have the grill model number and serial
number
printed on the black label, located inside the
left door of the cabinet.
If you need a replacement
part under warranty, a proof of purchase will be
necessary
. You will be asked to forward your proof of
purchase via e-mail or to fax your proof of purchase
to 423-639-1055 and reference your model and serial
number.
It is important to register your grill and
retain your receipt.
Connecting LP Gas Cylinder
1. Fill empty OPD LP Gas Cylinder at your local gas supplier.
2. Place the LP Gas Cylinder in the large hole in the Bottom Panel inside the cabinet. Lock the LP Cylinder in place by
tightening wing bolt on the outside rear of the cart base so that it seats against the ring base of the LP Cylinder.
3. Remove the protective cap from the LP Gas Cylinder valve. (Save cap for re-capping.)
Route the regulator hose out the HOLE in the Side Panel.
Hold Regulator in a straight line with LP Gas Cyl-
inder valve so the connection does not cross thread. Insert Regulator Nipple into the LP Gas Cylinder valve. Hand
tighten coupling nut in clockwise direction. DO NOT USE TOOLS.
Disconnecting LP Gas Cylinder
1. Turn all Control Knobs to the “Off” position and turn the handle on the
LP Gas Cylinder clockwise until it stops.
2. Turn coupling nut on regulator counterclockwise until regulator is
released from the threaded LP Gas Cylinder nozzle.
3. Place the protective cap over LP Gas Cylinder nozzle.
Cylinder nozzle
faces out toward
front of grill
Wing Bolt on outside
rear of cart base
Hand-tighten coupling nut
in clockwise direction
Route regulator hose OUT HOLE
To reduce the risk of serious bodily injury or death
from fire or explosion:
• Be sure to route the regulator hose, from the side
burner valve to the tank, UNDER THE LEG BRACE,
as shown below.
WARNING
!
Summary of Contents for Assie Vantage 67C3C8KK81 Use
Page 33: ...33...
