page 16
Appendix 1
Machine Guarding
7. If, after the assessment, it is considered that machine guarding is needed, then contact
your local supplier who, through Mecmesin, can arrange the supply of a suitable guard
for the required level of protection.
8. Once the machine is installed it should provide a reliable long term resource for
universal testing. If however the machine fails, or appears to behave in an unusual
manner, contact your local supplier for support. Do not continue to use the machine
until it has been checked, and if necessary, repaired and returned to a safe working
condition. To ensure optimal safe performance, your Vortex-
d
must be regularly serviced
and the ‘Smart’ loadcell calibrated by Mecmesin Limited or an authorised agent.
9. If the machine is damaged in use, advise your local supplier and have the machine
repaired to a safe working conditions. Do not use the machine until it is repaired.
10. It may occasionally become necessary to clean the outside of your test stand. This can
be done by disconnecting it from the mains electricity supply, removing loose debris
with a soft brush, then wiping with a damp cloth. Under no circumstances should
organics solvents or any other cleaning fluid be used.
IF IN DOUBT CONSULT YOUR LOCAL SUPPLIER TO ENSURE CONTINUED SAFE USE
11. The Vortex-
d
must be powered down when attaching/removing the cables.
Note:
no cable should exceed 3 metres in length. When the connectors are not
in use, please ensure that they are covered with the connector covers all
the time.