page 4
Assembly of
the Tornado
1.5N.m and 3N.m
When Tornado is in transit, the top
plate is removed to avoid damage
to the torque cell.
Fitting Instructions for the
Tornado Top Plate
Step 1. Tornado with
torque drive shown
Step 2. Align top plate
with torque drive.
The handle is
positioned to the
left.
Step 3. Tighten screws
finger-tight only.
Step 4. For use of Tornado
with handle at the
front, repeat steps
1 to 3 but position
top plate
accordingly during
step 2.
Unscrew the top plate handle so that the peg holders move
towards the outside edge of the plate. Align the top plate
with the torque drive so that the handle is on the left-hand
side of the top plate. Using the 2.5mm Allen key (provided),
tighten the four socket countersunk screws hand tight.
N.B. Do not overtighten as this may cause damage to the
delicate sensor
