page 24
The transmission (or Baud) rate can now be set.
Use the
UP
or
DOWN
key to position the arrow cursor at
the relevant speed (9600, 19200, 57600 or 115200).
Press
ENTER
to select.
Additional characters can be appended to the transmitted
load (RS232 only). These can be set to NULL (nothing), CR
(carriage return), LF (line feed) or CR LF.
Use the
UP
or
DOWN
key to position the arrow cursor at
the desired setting.
Press
ENTER
to select.
If required, a LINE DELAY, to be executed after each
reading is sent, can now be set.
Use the
UP
or
DOWN
key to set this value from 0 to 5
seconds in one-second intervals.
Press
ENTER
to select.
For use with continuous readings only, a % threshold for
the start of transmission can now be set.
Use the
UP
or
DOWN
key to set this value from 0% to
100%.
Press
ENTER
to select.
Method of transmission, RS232, DIGIMATIC or DUAL
(both), can now be set.
Use the
UP
or
DOWN
key to position the arrow cursor at
the desired setting.
Press
ENTER
to select.
The display will return to the COMMS sub-menu 1.
To set STORE MEM, move the arrow cursor against it in
COMMS sub-menu 1 and press the
ENTER
key. This will
cause a memory counter to appear in the main display, that
is incremented each time a reading is stored, by pressing
the
TXD
key. You will now return to COMMS sub-menu 1.
PORT sub-menu 3
(BAUD RATE)
PORT sub-menu 4
(TERMINAL)
PORT sub-menu 5
(LINE DELAY)
PORT sub-menu 6
(TX THRESHOLD)
PORT sub-menu 7
(TX METHOD)
COMMS sub-menu 1
(further options)
STORE TO MEMORY
