Set the ‘Mode’ rocker switch (F,in fig.1) to ‘Manual Control’
(upper position) and set the speed control knob to a mid-range
position (with pointer close to 12 o’clock). Hold the
‘Start/Stop’ centre-biased toggle switch (G, in fig.1) in either
the ‘Up’ or ‘Down’ position. A red LED (H, in fig 1) will
illuminate showing that the crosshead is moving, and
indicating the direction of travel. Releasing the Start/Stop
switch will stop the crosshead moving.
Set the Mode switch (F, in fig. 1) to ‘Single Cycle’ (lower
position), move the ‘Start/Stop’ switch (G, in fig. 1) to the ‘Up’
or ‘Down’ position and then release. The crosshead will move
and the LED indicating direction of travel will illuminate. When
a limit switch position is reached, the crosshead will begin to
travel in the opposite direction at full speed. When the position
of the other limit switch is reached, the motor will stop and the
crosshead will come to rest. During the cycle, setting the Mode
switch to ‘Manual Control’, or selecting either the ‘Up’ or’
Down’ position will stop the crosshead moving.
Manual operation
Single Cycle Operations
Note: Do not push or pull the
limit switches with your hand to
stop the stand - use the start/stop
switch
page 3
B - Upper limit
switch at rear
C - Crosshead
B - Lower limit
switch at rear
Fig.1
E F
A
H
G
Front control
panel of
MultiTest 1
B
B
C - Crosshead
Summary of Contents for MultiTest 1
Page 2: ......
