PAC KING INSTRUCTIONS FOR MULTITEST 1 AND MULTITEST 2.5 MOTORISED TEST FRAMES
WHEN RETURNING TO MECMESIN LIMITED
1.
Set the Crosshead to approximately the centre of the test frame. Remove the four rubber feet from
the base.
2.
Place the plastic foam collar over the column ensuring that the collar does not hang over the
base casting.
3.
Lay the test frame into the smaller box with the control panel facing upwards and with the base
facing the end with the four holes.
4.
Position the wooden back plate on to the box and retain the plate through the box to the base
casting using four M6x35 socket-head screws fitted with large M6 plain washers.
5.
Place all accessories listed to be despatched with the stand in the box with the test frame,
including the feet. Ensure that the accessories and operators manual/handbook are suitably
wrapped for protection in transit.
6.
Place two of the four plastic foam spacers into the outside box so that they will support the
ends of the inner box (longest sides uppermost).
7.
Carefully place inner box into outer box, ensuring that inner box rests evenly on foam spacers.
8.
Close and then seal the inner box with a suitable adhesive tape.
9.
Place the remaining two foam spacers over the ends of the inner box, so they will support the
ends as per the bottom two spacers.
10.
Close and then seal the outer box with a suitable adhesive tape.
11.
Attach despatch wallet with relevant paperwork for end destination.
page 8
Summary of Contents for MultiTest 1
Page 2: ......
