Page 21
MMAE16 - Servce & Parts Manual
Aprl 2022
Secton 10 - Mantenance
switch or the joystick when your reference point on the machine crosses the test line.
Measure the distance between the test line and your machine reference point.
Result:
The machine stops within the specified braking distance. No action required.
Result:
The machine does not stop within the specified braking distance.
Note:
The brakes must be able to hold the machine on any slope it is able to climb.
Replace the brakes and repeat this procedure beginning with step 1.
Braking Distance, Maximum
High range on paved surface
24 in±11.8 in
61 cm±30 cm
9) Test the Drive Speed - Stowed Position
Tools will be required to perform this procedure.
Proper drive functions are essential to safe machine operation. The drive function should respond
quickly and smoothly to operator control. Drive performance should also be free of hesitation, jerking
and unusual noise over the entire proportionally controlled speed range.
Perform this procedure with the machine on a firm, level surface that is free of obstructions.
Create start and finish lines by marking two lines on the ground 40 feet or 12.2 meters apart.
Turn the key switch to platform control. Pull out the ground and platform red Emergency Stop
button to the ON position.
Lower the platform to the stowed position.
Press the drive function select button.
Choose a point on the machine; i.e., contact patch of a tire, as a visual reference for use when
crossing the start and finish lines.
Bring the machine to top drive speed before reaching the start line. Begin timing when your
reference point on the machine crosses the start line.
Continue at full speed and note the time when your reference point on the machine passes over
the finish line. Refer to specifications.
10) Test the Drive Speed - Raised Position
Tools will be required to perform this procedure.
Proper drive functions are essential to safe machine operation. The drive function should respond
quickly and smoothly to operator control. Drive performance should also be free of hesitation, jerking
and unusual noise over the entire proportionally controlled speed range.
Perform this procedure with the machine on a firm, level surface that is free of obstructions.
Create start and finish lines by marking two lines on the ground 40 feet or 12.2 meters apart.
Turn the key switch to platform control. Pull out the ground and platform red Emergency Stop
button to the ON position.
Press the lift function select button.
Press and hold the function enable switch on the joystick.
7.
•
•
8.
•
1.
2.
3.
4.
5.
6.
7.
•
1.
2.
3.
4.
