MEC
–
Energietechnik GmbH
INSTRUCTION MANUAL
Atlas-300IM
Rev.2.0
–
22/04/2014
Page 2 of 4
www.mec-energietechnik.com
2. General Information
This microprocessor based IP-65 Lead Acid Battery Charger was especially developed for the outdoor use and for situations
where water may be present. It can be used to charge any lead-based battery
–
including GEL, AGM, WET and CA. With the 5-
step charging program the battery will be charged safely in a fully automatic mode. The output of the charger is electronically
protected against short circuit, reverse polarity connection. The charger is able to recover deep-discharged batteries.
Coloured LED
’
s on the top case are used to indicate charging status, errors, and selected mode of charging. Additional it includes
a power supply mode.
The chosen battery type could be changed on the control panel. The previously selected mode will be saved as standard setting.
3. Special Features
Passive cooled IP65 aluminium housing
Short circuit and reverse polarity protection
LED
’
s to indicate operation and charging status
5-Step charging technology with automatic restart
Selectable battery type (Gel, AGM, Wet or CA) and power supply mode
Battery temperature sensor
Automatic shut-off at too high temperature
Indicating a non-chargeable
(‘dead battery’) condition
Drive-Inhibit function
Protective vent
–
protection against condensation
Optional remote Display (only 571 IM)
4. Product Figure
1 AC-input cable
5 Yellow AGM-LED
9 Yellow Charge-LED 13 Temp-Sensor M4
2 DC-output cable
6 Yellow Wet-LED
10 Green Full-LED
14 Driving inhibition
3 protective vent
7 Yellow Ca-LED
11 Red Error-LED
15 Battery (+)
–
M 12
4 Yellow Gel-LED
8 Red Mains-LED
12 Select Mode Button
16 Battery (
–
)
–
M 12
4
5
6
7
8
9
10
11
12
13
14
15
16
1
2
3