Page 9 Rev. 1
ADJUSTING FROM SINGLES TO DOUBLES
As you can see in the photo below, the black knob is in the lowest slot on the aluminum component.
This position will pass the clays on to the next hole location in the top plate. To go to DOUBLES
simply lift the black knob vertically and twist 90 degrees. This will adjust the roller height and now
allow 2 clays to drop onto the throwing plate.
You may need to swivel the bogie wheel away from the clays to allow the wheel to move freely. This
can be done by pushing/pulling the nylon component to swivel the wheel away from the clays. See
photo on the next step.
1.
LOOSEN NUT
2. TIGHTEN OR LOOSEN NUT
TO DESIRED SPRING TENSION
3. RETIGHTEN BOTH
NUTS SECURELY
WHEN DONE!!!
