Page 20
84RT Seres Speed Level™ - Operator’s Manual
July 2021
Secton 6 - Functons Test & Operatng Instructons
Leveling Procedure
Leveling of the machine can only be performed when the platform height is below the Stowed Height
Limit Switch setting of approximately 10 feet (3 m).
An audible alarm will sound if the platform is out of level, and then the platform must be brought to
level or the LIFT function will not operate.
When operating on a sloped surface, the platform can be brought to level using the AUTO LEVEL
switch or the MANUAL LEVEL switches.
Note:
The tilt alarm must be off or the platform will not elevate.
Do Not drive elevated across uneven terrain (see Tip-over Hazards on
page 8)�����
ART_3238
Auto Level
Move the toggle switch DOWN to start leveling.
Hold the toggle switch DOWN until leveling operation is complete.
When the platform reaches the level position, the tilt alarm with stop
and the machine will stop correcting.
•
•
•
ART_3239
Manual Level: Front to Rear
Tilt to Front:
Move and hold the toggle switch to the LEFT to tilt the
platform to the desired position.
Tilt to Rear:
Move and hold the toggle switch to the RIGHT to tilt the
platform to the desired position.
•
•
ART_3240
Manual Level: Side to Side
Tilt to Left:
Move and hold the toggle switch to the LEFT to tilt the
platform to the desired position.
Tilt to Right:
Move and hold the toggle switch to the RIGHT to tilt the
platform to the desired position.
•
•
Shutdown Procedure
ART_3235
When finished with the machine, place the platform in the stowed
position.
Park the machine on a level surface.
Turn the key switch to the OFF position and remove the key to prevent
unauthorized use.
Carefully exit the platform using a constant three (3) point dismount/grip.
•
•
•
•
