Page 2 Version 3
Step 3
– The machine comes set to White Flyer standard clays. If using
something different you may need to check the height / clearance of the knife-
edges by placing a clay in the carousel. Rotate the carousel so that the clay
starts to pass underneath the inner and outer knife separator blades. The clay
must pass freely under the knife separator blades without binding but with the
minimum of clearance. Adjust if necessary with 7/16” open ended wrench. The
height on both the inner and outer knife edge will need to be adjusted. Photos
below show adjustment with carousel fitted, but you can remove the carousel to
make adjustment easier if preferred.
Step 4
– Now, you can lay out the battery terminals and control box at the back
of the machine. DO NOT CONNECT BATTERY AT THIS POINT.
