Mean Green Products STALKER, Owner'S Manual, Page: 39 / 48

A blade spindle is bent. Contact your Mean Green Products Dealer.
Loss of deck operation
The deck fails to operate with fully charged batteries.
RESET Mower Electronics by Switching Ignition Key to OFF position for approximately
5 seconds & then back to ON position. If this does not remedy the problem - Contact
your Mean Green Mower Dealer.
Mower will not start
Check that key is in the ON position.
Check all battery connections in back battery compartment.
Make sure batteries are charged.
Check to see that ALL circuit breakers are not tripped.
Mower blades stop due to low charge & mower will not move
Turn blades off, turn key to OFF position, wait approximately 5 seconds and then back
to ON(this resets computer)
If manual operation is needed to return to charging station or to move mower without
battery power, pull both Emergency Drive Brake Release Levers INWARD to release
drive brakes (located behind electronics bay cover and operator knee cushion and at
the end of each drive motor (2 each levers
SEE Page 20 Fig.6A & 6B ) and push or
tow mower slowly .
NOTE: Never drive mower with levers released. Always push levers back to the UP position before driving!
Failure to re-engage drive levers could cause serious damage to your mower and void mower warranty!!!!
STORAGE
When storing the unit at the end of the mowing season, the following steps
should be taken to ensure readiness for the next mowing season.
1. Remove all grass, dirt, and trash from mower.
IMPORTANT: Wash the machine with a mild detergent
and small amount of water. Do not pressure wash the machine . DO NOT saturate
machine with water! Avoid excessive use of water, especially near
the control switches and mower deck motors (located on deck of mower)
DO NOT get water in electrical compartment or in battery compartment!!!
IMPORTANT
: Excessive water use may void warranty if guidelines are not followed!
2. Check thoroughly for any worn or damaged parts that need replacing and order them from your dealer.
3. Thoroughly lubricate wheel bearings, according to lubrication instructions.
4. Fully charge batteries.
5. Do not deflate tires.
6. The mower should be stored in a well ventilated, clean
and dry place as the battery charger cannot be used in a wet environment. Connect
the battery charger to the charger port.
Leave battery compartment open!
Always keep the batteries fully charged. Especially important to prevent battery damage
when the temperature is below 32°F (0°C).
New season preparation
Before starting the mower following post season storage, the following servicing is required:
1. Clean machine, removing trash and dirt accumulation.
2. Review safety precautions listed in this manual.
3. Check and inflate rear tires to recommended pressure of 12 psi. If No Flat tires on front,
no air required. If pneumatic tires on front, recommended pressure is 12 psi.
4. Make sure that batteries are fully charged.
5. Grease wheel bearings (SAE multi-purpose grease)
32