Mean Green Products STALKER, Owner'S Manual, Page: 26 / 48

19
Deck cutting height adjustment (Located right side of mower chassis)
Deck height is adjustable from 1”- 4.5 inches in ¼ inch increments with 15 deck height adjustments. (fig.14)
To adjust deck height – Relieve tension off of Deck Height Adjustment Pin by pulling rearward on Deck Height
Adjustment Handle. Remove Deck Height Adjustment Pin and insert into desired Height Adjustment Hole.
Release pressure on Deck Height Handle to allow handle to rest back onto pin.
NOTE: To lock deck height adjustment in highest position for travel or
loading/unloading – Pull Deck Height Adjustment Handle completely rearward until
handle locks in highest position. To lower deck from highest position – pull rearward on
Deck Height Adjustment Handle
with one hand next pull rearward on Deck Height
Locking Handle with other hand , proceed to lower Deck Height Adjustment Handle to
desired height.
** See Illustration Fig.14**
Fig.14
Anti-scalp wheels (Fig.15)
Anti-scalp wheel kits are standard on Mean Green Mower units.
These anti-scalp wheels are designed to minimize scalping
when mowing on rough uneven terrain. After setting the cutting height, adjust
the anti-scalp wheels so they extend below the deck but
do not contact the ground.
They should always be at least 1/4” to 3/4” below the deck. With the unit sitting on a flat level
surface, the wheel position can be adjusted up or down as
needed from 3/4” to 1-3/4” below the blade surface. Move the wheels up or down, in 1/2”
increments, using the different axle mount holes in the wheel mount bracket. (if applicable on model)
Fig.15
IMPORTANT
READ!
Deck Height Adjustment Handle
Deck Height Adjustment Pin
Height Adjustment Holes
Deck Height Locking Handle