3
Product description
Performance description
10
V7.20160121
30302710-02-EN
Product description
Performance description
The terminal is available in two hardware versions:
▪ With GSM modem and with camera connections
– Complete functionality:
– It is the prerequisite for work with the farmpilot portal;
– On the rear side you can find two camera connections and one connection for the GSM
antenna.
▪ Without GSM modem and without camera connections
You can find out the terminal version you have on the connections on the terminal rear side.
All applications of Müller-Elektronik available are installed on the terminal. But first you must activate
some of them.
See also: Activating licenses for full versions of the software [
The following applications are activated:
▪ SERVICE – this application configures the terminal.
▪ TRACK-Leader – a modern system enabling the driver of an agricultural vehicle keep exact
parallel lanes on the field.
▪ Tractor-ECU - this application enables you to configure all sensors connected to the terminal and
to input the position of the GPS receiver.
▪ File Server - This application is used to define a save location on the terminal. This save location
can be used by all ISOBUS implements which do not have their own USB interface.
▪ Serial Interface - This application enables a data exchange between the terminal and an on-
board integrated display/controller via the serial interface. In this way, you can also use the GPS
signal for machines which are not ISOBUS-compatible. You can transfer target rates to the on-
board integrated display/controller or switch sections. The data is sent using the LH5000 or ASD
protocols.
– If you want to use the ASD protocol, you must activate the "ASD-Protocol" license.
You can test the following application for 50 hours free of charge:
▪ SECTION-Control – automatic boom section switching. Additional module for TRACK-Leader.
▪ VARIABLE RATE-Cont. – with this application you can work with prescription maps saved as
shp files. Additional module for TRACK-Leader.
▪ TRACK-Leader TOP – automatic steering. Additional module for TRACK-Leader.
▪ FIELD-Nav – this is the first navigation software that contains all navigable paths, takes
movement restrictions into account and leads directly to the field or other agricultural destination.
The following applications are installed, but deactivated until you have activated a license:
▪ ISOBUS-TC – this is the certified ISOBUS task controller from Müller Elektronik. In this
application you can use the terminal for processing all tasks previously planned on the PC.
▪ ISOBUS-UT - interface for controlling ISOBUS job computers. As soon as this application is
activated, the terminal complies with the ISOBUS standard ISO 11783. It can then be used as an
ISOBUS terminal (UT) on all implements that meet the requirements of this ISOBUS standard,
regardless of the manufacturer.
If you also want to operate ISOBUS job computers with the terminal, you must activate this
application.
3
3.1
Hardware
Software
