Function
Settings
deactivated.
Level for threshold value
indicator "On"
The switch-on threshold of the threshold value indicator can be
adjusted in steps of 5% within the range 0 to 100%. When 0% is
set, the threshold value indicator is deactivated.
Level for threshold value
indicator "Off"
The switch-off threshold of the threshold value indicator can be
adjusted in steps of 5% within the range 3 to 98%. The switch-off
threshold should be set lower than the switch-on threshold. If "0%"
is set, the switch-off threshold is deactivated.
Operating mode
"Actual value display" (Default), Maximum value display, Inversion
of the display, Non-volatile Tare setting (default) or volatile when
switched off, "Gradient" setting (special function, not included in
the standard configuration), TEDS activated (default) /
deactivated.
Load pre-setting
Selecting this menu option loads the default settings included on
delivery.
±10V, 2 mV/V, 100Hz, Actual value display, TEDS active, Non-
inverted display,
GSV-6K
Description
The measurement amplifier GSV-6K includes a strain gauge input via a 5-pin M12 casing
bushing and an analogue output via a 5-pin M12 housing connector.
The GSV-6K is used to convert the bridge signal from force, torque or strain sensors to an
analogue output signal.
The electronic data sheet of the sensor can be read via a TEDS interface. The
measurement amplifier scales the output signal to the end value of the set output signal
using the TEDS interface.
The output signal can be set as a voltage output or current output.
The outputs 0...10V, ±10V, 0...5V, ±5V, 4...20mA, 0...20mA can be set using the "Tare" and
"Scale" control cables.
Similarly, an offset or sampling frequency can also be set.
ME-Meßsysteme GmbH, Neuendorfstr. 18a, DE-16761 Hennigsdorf
Tel +49 (0)3302 78620 60, Fax +49 (0)3302 78620 69, [email protected], www.me-systeme.de
9
