MDS Mosfet C2, Installation Instructions & Owner'S Manual

Page: 7 / 16

M
OUNTING LOCATION
Before you start the installation, it will be necessary to find a mounting location for the
amplifier. Find a location in which the amplifier will receive adequate ventilation in order
to dissipate the heat it develops during operation. Two popular mounting locations are in
the trunk or under the seat.
Select the location in which you wish to mount the amplifier. Use caution when mounting
amplifier, there are many wires, gas lines, vacuum lines, brake lines as well as a gas tank
in the automobile. Make sure you know where they are when mounting the amplifier to
avoid puncturing lines, shorting wires or drilling holes in the gas tank. Once you are
ready, use a pencil to mark the mounting holes in the bottom panel. After you have
marked the locations of the holes move amplifier out of the way and drill small starter
holes to make the tapping screws easier to install. Use provided screws to tighten down
the amplifie
r.
6
X-OVER
X-OVER
FLAT
FLAT
LOW PASS
LOW PASS
HIGH PASS
80HZ
HIGH PASS
80HZ
FRONT REAR
L L
R R
POWER
INPUT
PROTECT
12dB
12dB
6dB 6dB
0dB
0dB
BASS
BASS
LEVEL
LOW PASS
LOW PASS LEVEL
100mV 8V 100mV 8V
250 50
250 50