MDM MDM-1 FOX, Flight Manual

Page: 25 / 54

MDM-1 „FOX” FLIGHT MANUAL
Appr. 4.5
Issue III
4.4 Pre-flight inspection.
1. Check securing of connecting elements and coupling in control systems, as in item 4.3.3.
2. Remove / fasten loose items in the cockpit, check reliable installation of balancing weights (if
present).
3. Put on the parachute.
4. Adjust the cockpit elements for comfortable position (pedals, back rest, cushion).
5. Take a seat in the cockpit, fasten the belts.
6. Ensure access to all devices.
7. Check full movement of controls.
8. Ensure the air brake is locked in retracted position.
9. Set the altimeter to "zero" reading.
10.Set the elevator trim to „nose heavy” position.
11.Close and correctly lock the canopy.
12.Connect the towing cable, check a reliable connection.
13.Make a communication test.
4.5 Normal procedures and recommended speeds.
4.5.1 Launch, run up, ground rolling.
1. Towing cable connection

Pull the release handle onto stop.

Insert the small ring of cable end into the hook and release the handle.
CHECK THE RELIABLE CABLE CONNECTION BY PULLING ON THE CABLE SEVERAL
TIMES!
2.
Winch-launching. - ON C.G. HOOK ONLY!

Prior to take-off, inform the winch operator that the increased launching speed must be maintained,
as for gliders with water ballast.

Before take-off, set the trimming device into:
1-st slot (counting from front) - for light pilot, solo,
4-th slot (from front) - two person crew.

In run-up maintain the stick neutral until lift-off.
DO NOT TRY THE PREMATURA LIFT-OFF.

When airborne, having gained the proper speed, the glider can gently pass into climbing.

On hitching a ground with the wing, release the rope immediately.

Recommended steep climbing airspeed is 110 through 120 [km/h] (59 through 65 [kt]).

Before releasing the towing cable the pilot should slightly unload the cable.

In case the cable exceeds the 80
o
angle, the automatic release will occur.

After releasing the cable, pull on the releasing handle in cockpit several times, and then pass into
gliding.
CAUTION: Do not change the setting of trimming device, while climbing.