MDC XT16-HR East West, Owner'S Manual

Page: 102 / 113

www.marketdirect.com.au
I
Ph: 1300 494 494
I
©Copyright
I P a g e | 100
60 MONTHS / 50,000KM SERVICE
CHECKED
Chassis and Suspension
Hitch
•
Inspect for damage and lubricate. Check bolt Torque to 90Nm
Jockey Wheel • Inspect for condition and operation
Breakaway
•
Check for correct operation.
•
Inspect lanyard and clip
Drawbar
•
Inspect wiring grommets and general condition
Suspension
•
Torque bolts to 190Nm
• Grease bushes and check for play.
• Check torque on suspension hanger bolts (190nm)
• Check retaining chain shackles tight.
•
Inspect shock absorber for condition.
•
Inspect shock absorber bushes
Brakes •
Inspect and adjust. Check lining thickness and drum wear
Wheel bearings
•
Replace bearings, seals and lubricate. Check stub axle condition
and wear. Replace split pin.
Wheel Nuts
• Inspect condition and torque to 125Nm (12mm studs)
(140Nm 14mm studs alloy rims) (200Nm 14mm studs steel rims)
Tyres
•
Inspect for abnormal wear, damage, and pressure.
•
Check manufacturing date less than 5 years.
• Check sidewalls for perishing and damage
12 volt electrical
Lights
• Check all trailer lights are functioning.
•
Check plug pins have gap.
•
Check for corrosion
Battery
• Check terminals and voltage at full charge.
•
Check batteries are secure in cradles
Charging
•
Check battery charger settings are correct.
• Check DC to DC charger settings are correct
Solar Panels
• Check panels are free of damage.
•
Inspect sealants on cable penetrations and junction boxes
Cables
• Inspect cables under body for damage to conduits.
• Inspect cable glands and sealants on penetrations through floor
240 volt Electrical
RCD Unit • Check operation of RCD via test button
Mains Input
•
Inspect mains input plug and cover are free of damage
Earthing
•
Carry out resistance check
Caravan Body
Hatches &
Doors
•
Check and lubricate locks
Seals
•
Check condition and correct latch/lock adjustment for correct 30-
50% compression
Body
•
Inspect joint sealants inside and out.
•
Ensuite joints checked for damage and adhesion.
•
Inspect for soft spots on floor
General fixings • Check all structural fixing are secure.
Ventilation
•
Inspect for obstruction and vents operating correctly