Mustang Dynamometer
MD-AWD-150
Page 34
10. Release the rolls by clicking lift then down on the top of the PowerDyne computer
screen
11. Start the vehicle, APPLY THE VEHICLE BRAKE, and put into forward gear.
SLOWLY release brake, or clutch, and rotate the tires very slowly (no not exceed
2 MPH). After vehicle has “settled” apply brake, put vehicle into park, and turn
engine off and raise the dyne lift. This procedure should only take 10 – 15
seconds.
12. Make sure the tires are clear of the dynamometer’s frame
13. After the vehicle is positioned properly it is
MANDATORY
to secure the vehicle
with straps.
14. Connect exhaust removal system.
15. Position the wheel chocks
IN FRONT
of the wheels that are not on the
dynamometers rolls.(again this step is only necessary if testing a rear wheel drive
vehicle when the front wheels are on the ramp system instead of the AWD roll
set section).
16. The dynamometer is now ready for its first rotational break-in test.
L
WARNING: T
HE
C
OMPUTER
S
HOULD
S
TILL
B
E
I
N
T
HE
M
AIN
M
ENU
S
CREEN
.
17. Be sure all personnel and equipment are clear of the rotating dynamometer and
that no personnel stand in front or directly behind the test vehicle.
18. Unlock rolls by clicking “lift” then down on the top of the PowerDyne display.
19. Start the engine and apply brake and/or clutch, place the vehicle in drive gear or
low gear.
20. Slowly release brake and/or clutch and check to see if the vehicle tires are
rotating on the dynamometer. D
O
N
OT
E
XIT
T
HE
V
EHICLE
,
C
HECK
W
ITH
Y
OUR
A
SSISTANT
.
L
WARNING: D
O
N
OT
A
CCELERATE
V
EHICLE
:
R
UN
A
T
I
DLE
.
B
E
S
URE
A
LL
P
ERSONNEL
A
RE
C
LEAR
O
F
V
EHICLE
.
21. Run vehicle for 2 – 3 minutes.
22. Listen for noises, feel and look for vibration. Be sure the vehicle does not sway
left/right or back/front. Check for anything unusual.
23. Be sure the driver stays in the vehicle and all personnel stay clear of the
dynamometer and of the front and rear of vehicle.
24. If there are any problems, stop the procedure immediately.
25. If no problem occurs, accelerate the vehicle in 10 MPH increments up to 50 MPH
for 2 – 3 minutes at each increment.
26. Repeat steps 22, 23, 24 as required.
Summary of Contents for MD-AWD-150
Page 1: ...Mustang Dynamometer MD AWD 150 Page 1 MD AWD 150 SERIES MANUAL REV A ...
Page 29: ...Mustang Dynamometer MD AWD 150 Page 29 INSTALLATION ILLUSTRATIONS 4 7 CONTROL INSTALLATION ...
Page 40: ...Mustang Dynamometer MD AWD 150 Page 40 ...
Page 49: ...Mustang Dynamometer MD AWD 150 Page 49 APPENDIX C ANCHOR POD INSTALLATION NEW FLOORS fl ...
