4
McQuay OM 920-1
Introduction
Introduction
This manual provides information regarding the MicroTech III control system. It specifically
describes the operation and programmable options for units with constant air volume (CAV)
control and variable air volume (VAV) control.
The MicroTech III Controller is a self contained device that is capable of complete, stand-
alone operation. Information in the controller can be displayed and modified by using the
keypad/display in the units main control panel. For installation and startup instructions and
general information regarding a particular unit, refer to the applicable model-specific
installation and maintenance manual.
For installation and startup instructions and general information regarding a particular rooftop
unit, refer to the applicable model-specific installation and maintenance manual (Table 1).
Table 1: Installation and Maintenance Resources
Unit
Manual
MicroTech III Rooftop Unit Controller - BACnet IP
Communications
IM 916
MicroTech III Rooftop Unit Controller - BACnet
MSTP Communications
IM 917
MicroTech III Rooftop Unit Controller - BACnet
LON Communications
IM 918
MicroTech III Unit Controller
IM 919
RPS/RDT/RFS/RCS 015C-105C
IM 926
RPS/RDT/RFS/RCS 050D-140D
IM 893
SWP Self-Contained (018 to 105)
IM 937
NOTICE
This equipment generates, uses, and can radiate radio frequency energy, and
if not installed and used in accordance with this instruction manual, may cause
interference to radio communications. It has been tested and found to comply
with the limits for a Class A digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user is required to correct the interference at his
own expense.
McQuay International disclaims any liability resulting from
any interference or for the correction thereof.
WARNING
Electric shock hazard. Can cause personal injury or equipment damage.
This equipment must be properly grounded. Connections and service to the
MicroTech II control panel must be performed only by personnel that are
knowledgeable in the operation of the equipment being controlled.
