653-042
P2007 Jens Broecking © Firma WJG, Braunschweig. Nachdruck oder Vervielfältigung nur mit ausdrücklicher Genehmigung
Funktions and Display:
Adjustments:
•
To toggle between „Heater“ and „Cooler“ press PWR and UP subsequently for three seconds.
•
To toggle between the temperature display in °C and °F press UP and DOWN subsequently for three
seconds.
•
If you press RESET the set value of the temperature will be set to 20 °C.
•
Press PWR once and no set value will be shown on display. The electricity will flow when the consumer
load is switched on. The LED of the temperature controller is off.
•
Press PWR twice then the temperature controller will display a set value of 25 °C and its LED shows red.
Now the device operates the consumer load according to the set up either as „Heater“ or „Cooler”.
•
With UP and DOWN you can adjust a set value of your desire.
•
Is the temperature controller operating a heater and the actual value of the room temperature is 2 ° (or
more) lower than the set value it will regulate it. Meanwhile the LED shows green and the „flame“-
symbol appears on the display.
•
Is the temperature controller operating a cooler and the actual value of the room temperature is 2 ° (or
more) higher than the set value it will regulate it. Meanwhile the LED shows green and the „snowflake“-
symbol appears on the display.
Temperature in Temperature in Function “Heater” Function „Cooler“
degrees Fahrenheit degrees Celsius
