www.Busse-Yachtshop.de - [email protected]
Page 12
6
ADVANCED OPERATION
This section provides a detailed description of the ‘advanced’ operation of your NAV6.
The three operating modes are described in detail. Remember to use the right-hand
MODE softkey to switch between the operating modes.
7
NAVTEX MODE
NAVTEX Mode is only available if a sensor is
(or has been) connected to the display and the
NAVTEX frequency setting on the NAVTEX
options page is set to 518 kHz, 490 kHz or
Both.
In NAVTEX Mode, the display consists of a
large area dedicated to displaying NAVTEX
messages, with a status bar at the top, and
descriptions of the softkey functions at the
bottom.
It is possible to scroll up and down the
messages line by line, using the UP and
DOWN keys. Additionally, you can step through
the display, message by message using the
LEFT and RIGHT keys.
Four different ‘views’ can be selected by pressing the VIEW softkey:
Message View
Print View
(when enabled in setup)
Sort View
Filter View
7.1
NAVTEX Mode, Message View
Used to view messages. Each new message can be accessed by a single key press
& then marked as read, if required.
The NEXT NEW softkey should be used to move the next new message to the top of
the NAVTEX display, where it can be marked as read by pressing MARK READ. Note
that the message that will be ‘marked as read’ is indicated in the top left of the status
bar. This is particularly useful when the message’s header has scrolled off the top of
the display area.
All manuals and user guides at all-guides.com
all-guides.com
