C1 S-VDR service manual
Issue 1
Page 5
Strobe radiation
The LED strobe light fitted to the EPIRB section produces intense flashes of light. No
damage is likely to be caused by intermittent exposure, but prolonged exposure
should be avoided.
Radio frequency radiation
Radio frequency radiation
The EPIRB section produces radio frequency radiation when it is activated. The
radiated level is below 13W with a duty cycle of 1%. Due to the low duty cycle this is
not considered to be a hazard
General precautions for chemical agents (adhesives, greases, IPA)
Observe all safety precautions relevant to the country of operation. As a general rule,
protective overalls, gloves and goggles should be worn when handling these
chemical agents, but different countries may have additional requirements which
must be observed.
Ensure that all chemical agents are handled in accordance with the manufacturer's
instructions, and that suitable protective clothing is worn.
Make sure that the working area is well ventilated, and that chemical substances are
not left exposed. Observe good hygiene practices; do not eat, drink or smoke when
handling chemicals.
Cyanoacrylate adhesives bond instantly on contact. If skin is bonded, it can usually
be released by a
gentle
peeling action; above all, do not panic and avoid direct
pulling on bonded skin.
Read the manufacturer's instructions before using any chemical agent.
Wear goggles
Wear overalls
Wash hands
Wear gloves
Summary of Contents for 36-001-001A
Page 1: ...C1 S VDR Service Manual ...
Page 2: ......
Page 4: ......
Page 6: ...C1 S VDR service manual Issue 1 Page 2 S VDR EPIRB in mount ...