MCM Electronics iRIS 8, User Manual

Page: 7 / 16

page 6
Fully Arming the System - ON Mode
Notes:
1. The system will not change to ON mode unless all section lights are
out or isolated.
2. Power light should be ON and not fl ashing.
3. Program, Fire and Auxillary lights,if fi tted, should be out.
4. Exit Timer starts as soon as ON light starts fl ashing and beeper gives
an exit warning.
5. Exit via programmed Exit/Entry sections only.
6. If the Exit / Entry sections are not sealed by the time the exit timer
expires then the siren and strobe will give 2 seconds warning and
the entry timer is started. If the system is not turned to OFF mode
before the entry time expires a full siren / strobe and alarm
transmission to the Central Station occurs.
Key Sequence Operation
Example shows a User Code 1 2 3 4
1 2 3 4 on
being used to change the system to
ON mode
Partially Arming the System - Partial Mode
Notes:
1. Only part of the system will be armed. Actual sections being
armed depends on setup by technician during installation.
2. The section lights of the sections which are being armed in Partial
mode must be out otherwise the system will not change to Partial
ON mode.
3. Check Power light is on and not fl ashing.
4. Program, Fire and Auxillary, if fi tted, lights should be out.
5. Exit Timer starts as soon as Partial light starts fl ashing and beeper
gives exit warning.
6. Exit via programmed Exit/Entry sections only.
7. If the Exit / Entry sections are not sealed by the time the exit timer
expires then the siren and strobe will give 2 seconds warning and
the entry timer is started. If the system is not turned to OFF mode
before the entry time expires a full siren / strobe and alarm
transmission to the Central Station occurs.
Key Sequence Operation
Example shows a User Code 1 2 3 4
1 2 3 4 part
being used to change the system to
Partial ON mode