IP Call-Suspend Setup, continued
2. Press
the
→
key to access the parameters.
Figure 5:
IP Call Suspend Settings
3. Press
the
→
key to the Enabled parameter. Press the
→
key to select
Ye
s
4. Press
the
↓
and
→
key to the
Timeout
parameter. This parameter causes the units to go into Call
Suspend mode when no activity occurs for the set Timeout value.
Note: Set the value between 15 and 240 minutes.
5. Press
the
↓
and
→
key to the Remote Only Wakeup parameter. Setting this parameter to
Yes
enables wakeup from Call Suspend on activity (for example, when a telephone set goes off-hook or a
key is pressed) at the Branch site only. If this parameter is set to
No
(disabled), incoming calls can
also cause wakeup from Call Suspend.
6. Press
the
↓
and
→
key to the
Mode
parameter. Press the
→
key to select
Lamp
or
Rin
g.
7. Press
the
↓
and
→
key to the
Indicators
parameter. Enter a list of monitored indicators separated by
commas.
8. Press
the
↓
and
→
key to the
ACD Tone
parameter. Press the
→
key to select
Yes
or
N
o.
Note
: Mode, Indicator, and ACD Tone are not supported by Norstar, Alcatel, or NEC.
9. Press
the
←
key to accept changes and go back to the Configuration Menu.
10. Press the
←
key to the
Save
parameter. Press
Enter
to save changes to the active config (.
re
m) file.
EXTender 4000 Universal Quick Installation Guide
22
