15
How to Program the CR12
cont
If the selected signal source is a component with a Play
function, such as a CD player, Video Disc player or tape
recorder, you can program to have the player start in Play
mode after its power turns on.
1. Press the Program push-button for the zone requiring a
Transport Play command.
2. Press the push-button for the signal source requiring the
transport play command.
3. Press the Transport Play push-button. The LED next to
the Transport Play push-button will turn on to indicate
the transport play command has been selected.
Note: Programming Accessory source on in combination
with Transport Play adds a 2 second time delay af-
ter a zone is turned on.
4. Press Program again or wait 10 seconds to exit the pro-
gramming mode.
How to program Transport Play
1. Press the program push-button for the zone requiring
Accessory source Control Off.
2. Press the push-button for the signal source requiring
Accessory source Control Off.
3. Press the Accessory Control Off push-button. The Red
LED to the right of the Accessory Control Off push-
button will turn ON to indicate that the Control func-
tion is OFF.
Note: Any source components connected for use in a
dedicated zone will not be affected by the Accessory
source Control Off function.
4. To exit the programming mode, press a Program push-
button again or wait 10 seconds.
How to program accessory control off
To change the previously programmed wakeup or turn on
signal source and volume level, using a keypad or remote
control.
1. Press a push-button for the desired new signal source.
2. Adjust the volume to the desired level.
3. Press and hold the new signal source push-button for 3
seconds.
4. The zone audio will mute, indicating that the change
has occurred. Release the push-button to unmute.
5. The next time that zone is turned on, the new signal
source and volume level will be in effect.
Remote Zone Programming with a keypad or
remote control
