use a file to square the corners and smooth any ir-
regularities in the cut edges.
5. Install the Mounting Strips
In the hardware package you will find two mounting
strips, four 6-32 x 1 1/4 inch fillister head screws and
two 4-40 x 1 1/4 inch inch flat head screws. These are
long enough for any cabinet panel thickness up to
one inch.
Starting at the right-hand side of the panel, insert
a 4-40 x 1 1/4 inch flat head screw into the center
hole in the panel, marked B on the template. On the
back of the panel, align a mounting strip with the
holes in the panel and tighten the screw until the
screwhead is pulled slightly into the wood.
Repeat this procedure to attach the mounting
strip to the left side of the panel.
6. Attach the PANLOC Brackets
Using two of the 6-32 x 1 1/4 inch fillister head
screws in the A holes on each side, attach the
PANLOC brackets to the cabinet panel; the short
flange is mounted against the front (face) of the
cabinet panel. The screws pass through the
PANLOC bracket flange, the cabinet panel, and then
through the mounting strips previously mounted.
7. Install the Instrument
Guide the AC power cord through the panel opening
to the back of the cabinet; then, slide the instrument
into the opening carefully so that the rails on the
bottom of each side of the chassis engage the
tracks on the mounting brackets. Continue to slide
the instrument into the cabinet until it is stopped by
the adjust position latches. Press the latches in-
ward. This permits the instrument to slide into the
cabinet until its front panel is flush with the cabinet
panel. Depress the PANLOC buttons at the lower left
and right corners of the instrument panel to lock the
unit firmly in the cabinet. Depressing the PANLOC
buttons again will unlock the instrument so that it
can slide forward to the adjust position. If you press
inward on the adjust position latches you can
remove the instrument from the cabinet.
3
