Installation Instructions
8
Installation steps
MLWINDSOR Digital Lock
1. First install and tighten the lock case according to the door opening direction, and install
the strike plate on the door frame.
2. Install the exterior assembly, the short spindle is installed into the front panel, then
please pay attention to the connection wire, pull it out from behind the door and sort it
out, then install the rear mounting plate behind the door, place the two screws into halfway
but don’t tighten them yet.
3. Adjust the spindle and the hole of the rear mounting plate, then tighten the two screws.
4. Install the interior assembly, the long spindle is installed into the rear panel, then check
whether the spindle spring has been installed in the spindle hole, then connect the wires
of the front and rear panel.
5. Tighten the four fixing screws, and install the screw hole rubber plug.
