24
Cyclonic Air Filter System
1.
Open the latches (A) and remove the cover (B)
2.
Remove the air filter (C)
3.
To loosen debris, gently tap the air filter on a hard surface. If the air filter is
excessively dirty, replace with a new air filter
4.
The cyclonic air filter system also has a safety filter (D) (if equipped)
5.
To remove, carefully pull the safety filter away from air cleaner body (E) and
discard. Make sure that dirt or debris does not enter the engine
6.
Install the new safety filter in the air cleaner body
7.
Install the air filter over the safety filter
8.
Install the cover and close the latches
Low Profile Air Filter System
1.
Remove the knob (F) and the cover (G)
2.
Remove the nut (H) and the retainer (J)
3.
Remove the air filter (K)
4.
Remove the pre-cleaner (L), if equipped from the air filter
5.
To loosen debris, gently tap the air filter on a hard surface
6.
If the air filter is excessively dirty, replace with a new air filter
7.
Wash the pre-cleaner in liquid detergent and water. Then allow it to thoroughly air
dry. Do NOT oil the pre-cleaner.
8.
Assemble the dry pre-cleaner to the air filter.
9.
Install the air filter and secure with retainer and nut.
10.
Install the cover and secure with knob.
Caution
Do not use pressurized air or solvents to clean the filter. Pressurized air can damage
the filter and solvents will dissolve the filter.
Summary of Contents for utrac MR18
Page 1: ...Scale Tractor Team trac MR18 Owner s Manual...
Page 29: ...29 Wiring Diagrams...
Page 30: ...30...