McFarlane WDL-2100, Operator'S Manual And Set-Up Instructions, Page: 27 / 57

27
Cable Adjustment
Slowly rotate the center bar into the transport position. Be sure the locks do not release before the
lift arms reach about a 45

angle.
If the lock bar unlocks too early in the lifting procedure, the lock
will be damaged.
If the center bar rotates all the way up and the locks do not release, the chains connecting the cables
and the lock arms must be shortened. Shorten the chains one link at a time until the lock bars release
as soon as the sections have been lifted off the ground and the lift arms reach about 45

angle.
Light Kit Installation
Refer to Figures 25, 26 and 27
1. Connect the wishbone extension (3 pin plugs on each end) to the wishbone harness (four pin
plug in the middle and 3 pin plugs at each end). Depending on model size, there may be one or 2
wishbone extension harnesses.
2. Lay out the wishbone and wishbone extensions on the toolbar. The plug on the wishbone
harness will be in the center of the unit and the light harnesses will generally follow the transport
cylinder hydraulic hoses. The three pin plug connects to the lights. Be sure to leave
approximately 2’ extra to run up the lift arm to attach to the lights. Do not attach to the frame.
3. Lay out the extension harness (seven pin connector on one end and a 4 pin connector on the
other end ) by plugging it into the wishbone harness that is laid out across the front of the lift
arms. Working towards the hitch, following the hydraulic hoses, and going through the hydraulic
hose brackets up to the hitch. Secure the wire harness to the hydraulic lines periodically with
electrical ties. Make sure there is plenty of slack to connect to the towing vehicle.
Figure 25