McFarlane WDL-2100, Operator'S Manual And Set-Up Instructions, Page: 26 / 57

26
Attach the Main Pull Tube to the Pivot Bracket
1. Attach the main pull tubes to the pivot brackets with the 1 1/2” x 8 5/16” pin. Refer to Figure 23
2. Secure the pin with a 1/2” x 3 1/4” grade 5 bolt and locking hex nut.
Figure 23
Attach the Main Pull Tubes to the Wing Anchor Bracket
1. Be sure the wing is in line with the center bar. Using the pull tube as a guide, attach the main
pull tube anchor assembly to the wing in the approximate position shown in Figure 24. Use eight
3/4-10 x 10, grade 8 bolts and locking
hex nuts and a clamp plate. Do not tighten bolts yet.
Attach the pull tube to the wing anchor bracket with the 3/4-10 x 5, grade 5 bolt and locking hex
nut and the 5/8-11 x 4 grade 5 bolt and locking hex nut with the bushings and pin as shown.
After all components have been assembled tighten all fasteners securely.
Figure 24