This power unit can be dangerous! Operator is
responsible for following unit manual instructions and
warnings. Read entire operator’s manual before using
unit! Be thoroughly familiar with the controls and the prop-
er use of the unit. Restrict the use of this unit to persons
who read, understand, and follow unit, manual instructions
and warnings. Never allow children to operate this unit.
1.
Wear close fitting, tough work clothing
that will
provide protection, such as long slacks or trousers,
safety work shoes, heavy duty work gloves, hard hat,
a safety face shield, or safety glasses for eye protec-
tion and a good grade of ear plugs or other sound
barriers for hearing protection.
2.
Store in a safe place.
Open fuel cap slowly to release
any pressure which may have formed in fuel tank. To
prevent a fire hazard, move at least 10 feet (3 metres)
from fueling area before starting.
3.
Turn unit off
before setting it down.
4.
Always hold unit firmly with both hands,
the
thumb and fingers encircling the handles.
5.
Keep all screws and fasteners tight.
Never operate
your equipment when it is improperly adjusted or not
completely and securely assembled.
6.
Keep handles dry,
clean and free of fuel mixture.
7.
Keep stringhead as close to ground as practical.
Avoid hitting small objects with trimmer head. When
cutting on a slope, stand below trimmer head. NEVER
cut or trim on a hill or slope, etc. If there is the slighte-
st chance of slipping, sliding or losing firm footing.
8.
Check area you will be trimming for debris
that
may be struck or thrown during operation.
9.
Keep all parts of your body and clothing away
from trimmer head
when starting or running
engine. Before starting engine, make sure trimmer
head will not come in contact with any obstacle.
10.
Stop engine
before examining cutting line.
11.
Store equipment away from possible flammable
materials,
such as gas-powered water heaters,
clothes dryers, or oil-fired furnaces, portable
heaters, etc.
12.
Always keep
the debris shield, trimmer head, and
engine free of debris build-up.
13.
Operation of equipment
should always be restricted
to mature and properly instructed individuals.
14.
WARNING:
The emission of exhaust gases is toxic.
15. Emergency Stopping Procedure. When it is neces-
sary to stop engine immediately, DEPRESS the
switch to stop.
16. This unit has a clutch. The routine for checking that
the clutch is working correctly is that when the engine
returns to idle the trimmer head stops spinning.
110
7600 min
-1
2
1
WARNING!
When using petrol tools, basic safety precautions, including the following, should always be followed to
reduce the risk of serious personal injury and/or damage to the unit.
Read all these instructions before operating this product and save these instructions.
WARNING!
This machine produces an electromagnetic field during operation. This field may under some circumstances
interfere with active or passive medical implants. To reduce the risk of serious or fatal injury, we recommend persons with
medical implants to consult their physician and the medical implant manufacturer before operating this machine.
WHAT TO DO
1. DO NOT USE ANY OTHER FUEL than that recom-
mended in your manual. Always follow instructions in
the Fuel and Lubrication section of this manual. Never
use gasoline unless it is properly mixed with 2-cycle
engine lubricant. Permanent damage to engine will
result, voiding manufacturer’s warranty.
2. DO NOT SMOKE while refueling or operating equip-
ment.
3. DO NOT OPERATE UNIT WITHOUT A MUFFLER
and properly installed muffler shield.
4. DO NOT TOUCH or let your hands or body come in
contact with a hot muffler or spark plug wire.
5. DO NOT OPERATE UNIT IN AWKWARD POSI-
TIONS, off balance, outstretched arms, or one-hand-
ed. Always use two hands when operating unit with
thumbs and fingers encircling the handles.
6. DO NOT RAISE TRIMMER HEAD above ground level
while unit is operating. Injury to operator could result.
7. DO NOT USE UNIT FOR ANY PURPOSES OTHER
than trimming lawn or garden areas.
8. DO NOT OPERATE UNIT FOR PROLONGED PERI-
ODS. Rest periodically.
9. DO NOT OPERATE UNIT WHILE UNDER THE
INFLUENCE OF ALCOHOL OR DRUGS.
10. DO NOT OPERATE UNIT UNLESS DEBRIS SHIELD
AND/OR GUARD IS INSTALLED AND IN GOOD
CONDITION.
11. DO NOT ADD, REMOVE OR ALTER ANY COMPO-
NENTS OF THIS PRODUCT. Doing so could cause
personal injury and/or damage the unit voiding the
manufacturer’s warranty.
12. DO NOT operate your unit near or around flammable
liquids or gases whether in or out of doors. An explo-
sion and/or fire may result.
13. DO NOT USE ANY OTHER CUTTING ATTACHMENT.
Use only Mcculloch replacement parts and acces-
sories, which are designed specifically to enhance the
performance and maximize the safe operation of our
products. Failure to do so may cause poor perform-
ance and possible injury. Use only the stringhead sup-
plied with this product.
Do not use any other cutting
attachment
. Use of such attachments will void your
factory warranty and could result in serious bodily
injury.
WHAT NOT TO DO
SPECIFICATIONS
Model No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .MT 260 CLS
Engine Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Air-cooled, 2-Cycle, Chrome Cylinder
Displacement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .26cm
3
Dry Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5.00 kg
Fuel Capacity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .550 cm
3
Bump Head . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Twin Line Bump Feed
Drive Shaft Length . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .66+66 cm
Cutting Width . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .43cm
Handle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .“D” Handle
Ignition . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Electronic
Drive . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Centrifugal Clutch
Sound levels (see note 1)
Equvialent sound pressure level at the operators ear……………………………98.37 dB(A)
Noise emissions (see note 2)
Measured sound power level……………………………………………………107.31 dB(A)
Guaranteed sound power level………………………………………………… .110 dB(A)
Vibration (K=1.5) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.796 m/s
2
Maximum Engine Performance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .0.78 kw
Engine Speed (rotationa lfrequency) at recommended
max. spindle rotational frequency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7800 min
-1
Maximum rotational frequency of the spindle (Max.) . . . . . . . . . . . . . . . . . . . . .7800 min
-1
Idle speed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3000±300 min
-1
Specific fuel consumpion . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 415.3 g/kWh
Note 1: Equivalent sound pressure level, according to ISO 22868, is calculated as the time-weighted energy total for different sound
pressure levels under various working conditions. Typical statistical dispersion for equivalent sound pressure level is a standard
deviation of 1.5 dB (A).
Note 2: Noise emissions in the environment measured as sound power (Lwa) in conformity with EC directive 2000/14/EC.
Meaning of symbols marked on the product
Read the user manual before using the machine
Warning! Hot surface
Keep people or animals at least 15m away from
the machine during operation
Wear gloves to protect your hands
Wear foot protection
Warning! Cutting elements continue to rotate
after the engine turned off.
Beware of thrown objects
Guaranteed sound power level LWA accordance
with directive 2000/14/EC + 2005/88/EC
Do not use metal blades
Maximum rotational frequency of the spindle for
cutting head
DANGER:
Never use blades, wire or flailing
devices. Unit is designed for line trimmer use
only. Use of any other accessories or attach-
ments will increase the risk of injury.
WARNING:
Keep children, bystanders, and
animals 50 feet (15 metres) away. If
approached stop unit immediately.
GB
GB
GENERAL SAFETY RULES
Whenever the machine is in use, safety glasses
must be worn to safeguard against flying objects.
Hearing protection must also be used in order to
protect to operators hearing.
110
Tighten the cap of oil and fuel tank to prevent the loss
of oil and fuel during transport
17.
It is recommended that daily inspection before use
and after dropping or other impacts to prevent
significant damage or defects.
18.
Prolonged use of this product expose the operator to
vibrations and may produce ‘whitefinger’ disease. In
order to reduce the risk, please wear gloves and
keep your hands warm. If any of the ‘whitefinger’
symptoms appear, seek medical advice immediately.
19.
Sound pressure level at 7,5 metres.