8
9.4.
Using a T-25 Torx driver, remove the screw
attaching the pawl retainer to the pulley housing.
See Figure 25.
NOTE:
There is a spring under the retainer.
9.5.
Replace the pawls if they are worn.
NOTE:
During assembly, note the proper orien-
tation of the pawl retainer. The pawl retainer
slots will face the same direction as the pawls.
See Figure 26.
9.6.
If the starter return spring is broken, lift of the
spring retaining cover and replace the spring.
See Figure 27.
9.7.
If the starter cord is broken, attach one end of
the starter rope to the pull handle. Pass the lose
end of the cord through the starter housing
assembly and through the pulley. Knot the end
of the cord and make sure it is secure in the pul-
ley. See Figure 28.
9.8.
Wind the starter cord around the pulley. Wind the
starter pulley clockwise to put tension on the
spring during the last loop of the starter cord.
Figure 25
Torx Screw
Figure 26
Figure 27
Notch
Spring Retainer Cover
Figure 28
Hold spool in place and wind cord clockwise.
Place tension of spool during last two winds.
