™
D
URA
M
AG
6.
Converter Boot
Enclosure
Lip
Press Down
Pull away and lift from two
corners to remove.
IMPORTANT
It is HIGHLY recommended that the boot be
utilized at all times when the meter is not being
read. The boot adds protection to the meter and ensures
proper closure of the lid, ensuring the maximum battery life.
I
The Dura Mag comes with a boot to help protect
the meter. The boot simply slips over the electronics
enclosure. When installing the boot, ensure the corners
of the boot fit snugly over the lip of the enclosure. To
remove the boot, grip two corners and pull them away
from the lip of the enclosure and then pull upwards.
5.
Activating The Display
CAUTION:
If the lid is broken off, contact the Factory for a lid replacement
kit. In the meantime, set the lid on the meter in its proper
position and use the boot to hold it in place.
I
The converter display is light activated and requires a minimum
amount of light to appear. Environments where light is low,
such as in dimly lit buildings or outdoors after sundown may
prevent the display from appearing when the lid is raised.
There is an optical sensor embedded in the display located under
the McCrometer “swirl” logo at the lower left. If the display does not
appear, a flashlight will provide sufficient light to bring it up.
NOTE
The display is activated when the lid is opened.
The display will remain active for 30 seconds.
The various parts of the interface screen
is shown below. Depending on how the
converter is configured with the configuration
tool the display will show either single
direction or bidirectional total flow quantities.
Bidirectional flows are represented as either
positive (POS) or negative (NEG), as shown at
right.
12345
123456789
GAL
GPM
x1000
12345
123456798
123456789
POS
NEG
GAL
GPM
x1000
Rate
Rate
Totals
Total
Total unit
Total unit
Multiplier
Multiplier
Rate unit
Rate unit
Alarms
Alarms
30122-61 Rev. 1.4 | 04OCT2021
Page 7
