™
D
URA
M
AG
Attaching conduit directly to the enclosure may
introduce dangerous gasses and moisture into
the enclosure creating a dangerous condition, and
will remove the enclosure’s IP67 rating.
Damage caused
by attaching conduit to the enclosure or altering the
enclosure in any way is not covered by the warranty.
IMPORTANT: Do not cut or alter the cable length
on power or signal cables!
Connections to the sensor must be made with cable
supplied by McCrometer specifically for that purpose. Do
not substitute the supplied cable with other types of cable,
even for short runs. For repairs or added lengths of cable, the
entire cable between the sensor and the converter must be
replaced. (Consult factory for replacement cable.)
!
I
Mounting the ProComm GO Converter
Note: This applies to the remote mount converter only.
If possible, mount the converter in an electronics shed or environmental
enclosure. The sun shield should be oriented in a direction to reduce sun
damage and ensure readability.
Mount the converter to a solid surface using four bolts. This electronic unit
is rated IP67 for temporary flooding.
2.
Remote Mount Converter Installation
Installing Cables through Cable Glands and Conduit
All electrical cables enter the converter through compression fittings or
optional customer-supplied conduit located on the side or bottom of the
converter. Ensure that all compression glands are properly tightened and
all unused fittings are plugged so the case remains sealed.
The power cable and wiring harnesses are each assigned specific cable
glands where they will pass through into the converter. See section 3 for
cable gland assignment for wiring harnesses and wiring diagrams.
All cable compression glands must be properly tightened to prevent
moisture intrusion and maintain the IP67 rating. To insure IP67 rating, use
only round cable 0.24” to 0.47” in diameter.
30122-61 Rev. 1.4 | 04OCT2021
Page 3
