47
/Stext[CR]
Slave Transmit Message
Write the specified data bytes to a requesting I
2
C Master Receiver device.
/(*)Ttext[CR]
Master Transmit Message
Master Transmit the specified data bytes to the current Destination I
2
C Slave
device. * = No Stop for Repeated Start.
/Un[CR]
I
2
C Bus Time-oUt
Set I2C Bus Time-oUt in msec (0=Disable)
/V[CR]
Display Firmware Version
(Major XX.XX Minor)
/X[CR]
eXtended Commands
(See Prompt or User’s Guide)
/(*)Y[CR]
Display Tx bYte Count
Display number of data bytes last sent to slave device
(Requires iPort/AFM Firmware v2.0+, iPort/AI 2, iPort/AFM 2, iPort/USB,
i2cStick, iPort/USB 2, iPort/LAN 2). *= Also display last received Ack bit
received from slave device (Requires iPort/AI 2, iPort/AFM 2, i2cStick,
iPort/USB 2, iPort/LAN 2).
Synchronous Interface Events
Synchronous Events are those iPort/LAN 2 interface activities initiated by the Host
computer.
iPort/LAN 2 Reset
Reset iPort/LAN 2 to its default state.
The reset command consists of three (3) sequential Ctrl/R characters. Ctrl/R is the
character code Decimal 18 and Hexadecimal 0x12. When using a terminal emulator
program, you can generate a Ctrl/R by holding down the Ctrl key and pressing the R
key.
Note: It is recommended that the Host computer turn off all serial port flow control
before sending this command to override any flow control from the I
2
C adapter that
could block the transmission. Flow control should be enabled once the response is
received.
Command: Ctrl/R,Ctrl/R,Ctrl/R ‘iPort Reset
Response. *
‘iPort/LAN 2 Ready
Default Setting:
None
