Installation and use
SOLID CONTROL MCK 2200
13
Once the count is complete, the power supply to the solenoid valve is disconnected
and the product output is blocked.
Each time the solenoid valve is opened, the 2 bars at the top of the SV.DCHA display
(ref. O3) will light up. These bars will remain on for as long as the opening status of the
solenoid valve lasts.
N.B. The solenoid valves are only activated if the keys ref. D, E, I are in the "START"
configuration (LED off)
The GENERAL START/STOP key (ref. E) has priority over the status of the two
sectionswhen the following is pressed:
START/STOP GEN→ON SECTIONS→ON;
START/STOP GEN→OFF SECTIONS→OFF.
The LEDs of the three keys mentioned above follow the status of the function
associated with them.
The two sections can work both in automatic mode, both in manual mode or mixed.
The automatic mode can be enabled on the two sections separately with the two
relative keys (ref. B and N). Entering the setting is indicated by the relative green LED
going on.
For the simultaneous switch of the two sections to automatic mode, the following key
will be used (ref. E): “AUTO/MAN GENERAL”.
The enabling of this setting is indicated by the relative green LED going on. This key
(ref. E) has priority over the status of the two sections when the following is pressed:
AUTO/MAN GEN→ON SECTIONS→ON
AUTO/MAN GEN→OFF SECTIONS→OFF.
The LEDs of the keys mentioned above follow the status of the function associated
with them.
The count of the total distributed litres and that of those left in the barrel is based on
the pulses coming from the flowmeter sensor, but is subject to the fact that at least one
of the two sections is active; if both sections are not active, any pulses coming from
the flowmeter will be ignored.
4.9
Manual mode
You can proceed in two ways to switch from automatic to manual mode:
1)
– at any time, by pressing the "AUTO/MAN GENERAL" key (ref. E) on the
computer, the green LED of the key goes off and the computer starts to work
in manual mode with both sections.
2)
– at any time, by pressing one of the two "AUTO/MAN - SV. IZQD" or
"AUTO/MAN - SV. DCHA" keys (ref. B and N) on the computer, the green
LED of the pressed key will go off and the relative solenoid valve will start to
work in manual mode.
