22
Installation/Setup
Acceptance test (in case of industrial/public use):
Before first use and after any significant modifications, the installation (including the electrical
connections) must be checked by an official expert.
A yearly inspection by a technical expert is required.
At least every four years, a quality inspection must be carried out by an official expert.
• Attach the two included mounting brackets to the casing with the lateral thumbscrews.
• If you want to set up the effect light, turn the two mounting brackets so that they form a base and then tighten the
two thumbscrews.
• If you want to suspend the effect light, turn the two mounting brackets upwards, so that the assembly holes in
the brackets match.
• Install the effect beamer on the ceiling, the wall or a suitable crossbeam with the mounting bracket. Make sure
that the device cannot swing freely.
• Secure the device with fastenings that are compatible with the fastening surface and suitable for carrying the
weight of the light effect device.
• Also secure the installation with a suitable safety restraint cable or a safety net to be hooked into the ring screw
at the casing. The safety restraint cable or the net must be designed to support the light effect in the event of a
fault in the main support system.
• Set the desired angle of inclination and tighten the thumb screws well.
