MBS UBR-01 | Mk II
Installation
15 von 46
Assembly / Disassembly
The device must be mounted on a top-hat rail (DIN top hat TS35
according to EN 60715). The top-hat rail bracket is pre-assembled on
the back of the device. The bracket is hooked into the top-hat rail from
above and fixed to the underside of the bracket with a clearly
perceptible click.
Warning
Electric shock injury hazard!
The device may only be installed in a control cabinet (top-hat rail)
when the power is disconnected.
The system must be disconnected for installation.
Notice
A sufficient distance
(≥ 15 mm)
to the other components on the top
hat rail is recommended for mounting the device in the control
cabinet.
This ensures better heat dissipation, which can have a positive
influence on the service life of the device.
Disassembly is carried out by unlocking the bracket on the underside
and carefully removing it from the top-hat rail.
Notice
Connecting cables should be unplugged during disassembly, to
avoid damage.
Power connection
The device is
exclusively
operated with protective extra low voltage
(PELV). The permissible voltage range must be taken from chapter 5
Specifications and connected loads
.
