MBM MBM 208J, Operation Manual

Page: 19 / 24

17
6. Maintenance (
Cleaning and replacement of consumable items
)

Keep roller cover closed to prevent dust from accumulating on the rollers.
 Clean the rollers regularly using a cleaner suitable for rubber rollers or a cloth slightly dampened with
water. Do not use solvents or aerosol sprays.
 If paper dust or ink accumulates on the paper rollers or separator, the paper feeding function will
deteriorate and may cause a paper jam or slipping. If this happens, clean them using a cleaner suitable for
rubber rollers or a cloth slightly dampened with water. Do not use solvents or aerosol sprays.
 Remove any dirt on the exterior parts using alcohol or appropriate cleaner. Do not use solvents.
Two rollers can be removed and installed without using tools. These two can be easily cleaned along with the
paper ejection photo sensor.
As the other two rollers cannot be removed, they should be cleaned while slowly revolving them by hand.
If only one sheet of paper is being fed, use a soft cotton swab to remove paper dust, etc. from the face of the
paper ejection photo sensor shown by the arrow.
(1) Removing the rollers
Remove the upper roller in the order of
１ to ３ , and
then remove the lower roller.
１ Move down the roller setting lever to the OFF
position.
２
Slide the roller to the right.
(Its shaft will come off from the left-side hole.)
３
Remove the roller from the right-side hole.
(2) Setting of the rollers
In the reverse order of removal, set the lower roller
first.
[1] Insert the roller deep to the right.
[2] Slide the roller to the left.
* Be careful not to let the roller shaft on both sides get
stuck on Part A.
As shown above, the roller shaft should be placed on
Part A.
[3] Move up the roller setting lever to the ON position.
Caution!
If the roller is not firmly fixed, it may cause operating problems.
If it cannot be fixed, contact your dealer.