5
3. How to use
3.1 Setting Perforating Block
((1) Loose Thumb Screw and squeeze
Release Levers by fingers to slide
Perforating Block right or left.
Refer guide scale.
NOTE:
Before setting Perforating Block, make
sure to place Blade Position Reference
at center position so that fine adjustment
may be possible after the Block is
installed. Refer 3.3.1 Fine Adj. Dial
- PERFORATION UNIT
CAUTION:
Perforating Blade is designed always to be pressed against Blade Receipt Roller.
Do not move the Roller without squeezing Release Levers. When Levers are
squeezed, they give distance between Blade and Roller.
CAUTION:
While fixing Thumb Screw, press Thumb Screw towards Block Mounting Arm so
that Perforating Block sets square to Block Mounting Arm. This helps the paper
to be fed straight.
CAUTION:
Roller Fixing Screw must be fixed at the position where Transport Shaft has flat
cut. Otherwise, the Blade Receipt Roller will not be fixed to the Shaft and the
Roller may be damaged.
Perforating Blade
Block Holding Arm
Thumb
Screw
Blade Receipt Roller
Roller Fixing Screw
Roller Fixing Screw
Fine Adjustment Dial
Thumb Screw
Blade Position
Reference
Release Lever
1
２
Fine Adjustment Dial
Guide Scale
(2) Fitting and fixing Blade Receipt Roller
- Loosen Roller Fixing Screw by Phillips Screw
Driver and place Blade Receipt Roller fit to the
Perforating Blade. Then fix Roller Fixing Screw.
Summary of Contents for 1800S
Page 2: ...1 ...
