MB QUART NANO NSC750, Installation Manual

Page: 20 / 24

FUSE
POWER INPUT
GND REM
SPEAKER OUTPUT
POWER
PROTECT
12V FUSE
POWER INPUT
GND REM
SPEAKER OUTPUT
POWER
PROTECT
12V
FUSE
POWER INPUT
GND REM
SPEAKER OUTPUT
POWER
PROTECT
12V FUSE
POWER INPUT
GND REM
SPEAKER OUTPUT
POWER
PROTECT
12V
FUSE
POWER INPUT
GND REM
SPEAKER OUTPUT
POWER
PROTECT
12V FUSE
POWER INPUT
GND REM
SPEAKER OUTPUT
POWER
PROTECT
12V
SLAVE MASTER
Subwoofer
2 – 8 Ohms
The Impedance may not
be lower than 2 ohms.
MASTER/SLAVE Link
like described on page 19.
SLAVE MASTER
Subwoofer Voice Coil 1
1 – 8 Ohms
Subwoofer Voice Coil 2
1 – 8 Ohms
The subwoofer voice coil on the SLAVE amp needs
to be connected with a converse polarity.
SLAVE MASTER
Subwoofer 1
1 – 8 Ohms
Subwoofer 2
1 – 8 Ohms
The subwoofer on
the SLAVE amp needs
to be connected with a
converse polarity.
MASTER/SLAVE Link
like described on page 19.
MASTER/SLAVE Link
like described on page 19.
INTERCONNECTION SUBWOOFER
• Connect the Subwoofer terminals with the speaker outputs (SPEAKER / -) of both amplifiers by using appropriate wires.
• Always ensure the correct polarity of the speakers. The interchange of plus and minus cause total loss of bass playback and could
damage the speakers.
• Ensure by any means, that the total impedance load of subwoofer is not lower than described above.
• Too low impedance cause high temperature and will shut down the amplifier operation.
INTERCONNECTION EXAMPLE 1 Subwoofer with a Dual-Voicecoil
INTERCONNECTION EXAMPLE 2 Subwoofers with Single-Voicecoils
INTERCONNECTION EXAMPLE 1 Subwoofer with a Single-Voicecoil
I N T E R C O N N E C T I O N E X A M P L E S
NSC750
20