Instr 9927916
Rev 01 2017-11
Page 7 of 11
iii. Remove three push pin rivets
F
from RH
side of dash: two inside upper storage area
and one on underside of dash.
iv. Remove upper dash from vehicle.
4. Install speakers and speaker harnesses.
a. Using 1/8 inch (3 mm) drill bit, drill out four
fastener dimples
G
. Only drill deep enough to
penetrate panel surface and enter pre-drilled
bosses on opposite side of panel.
NOTE
All holes drilled from rear (passenger) side of panel.
Forward side shown below for reference only.
b. Reaching down through upper dash cavity,
route spade terminals 4D and 4E on speaker
harness
r
down through hole in speaker
compartment, then secure grommet 4C in hole.
NOTE
See previous section,
HARNESS DETAIL
, for
connector identification.
c. Join speaker harness
r
to speaker
e
:
i.
Connector 4E (1/8 inch spade, BLACK
wire) to negative (–) terminal on speaker
ii. Connector 4D (3/16 inch spade, RED wire)
to positive (+) terminal on speaker
d. Install LH speaker
e
into speaker
compartment using four screws
w
. Do not
overtighten screws.
e. Repeat Steps 4a. through d. for RH side using
speaker
y
.
