Instr 9927916
Rev 01 2017-11
Page 10 of 11
e. Thread antenna mast
i
into antenna base
a
.
7. OPTIONAL: Install auxiliary input.
a. Gain access.
i.
Remove two push pin rivets
N
from lower
face of control panel. Retain rivets.
ii. Rotate bottom of control panel rearward,
disengaging two side tabs
P
, then drop two
upper tabs
Q
out of slots in main dash
panel.
iii. Label and disconnect electrical harnesses
from switches, sockets, or other devices in
control panel.
b. Drill 1 inch diameter hole through lower center
cavity for installation of auxiliary input
u
.
Remove nut and rubber gasket from auxiliary
input
u
, route wires rearward through opening,
then reinstall gasket and nut.
c. Reconnect electrical harnesses disconnected
in Step a. above, then reinstall control panel
using two retained rivets
N
.
NOTE
Auxiliary input will be connected to head unit in Step
9.
8. Reinstall all access EXCEPT upper dash
cupholder. See Step 3.
9. Hold head unit
q
near upper dash cutout and
make the following connections:
a. Join connector 5A on harness
t
to connector
1A on head unit
q
.
b. Join connector 11A on antenna harness
s
to
connector 1D on head unit
q
.
c. Join connector 7A on auxiliary input
u
to
connector 1B on head unit
q
.
d. Join connector 7B on auxiliary input
u
to
connector 1G on head unit
q
.
10. Install head unit (with bezel) into upper dash
cutout using two retained push pin rivets
A
.
