ENGLISH
ENGLISH
ENGLISH
ENGLISH
•
FIRST INSTALLATION
For the correct use of the grinding blades, at the first installation or whenever the grinding
blades have been replaced, grind some doses of coffee. Do not use those first doses.
In the Electronic Grinder-Doser version, for the appliance to function at its best, on its first
installation and every time the hopper is cleaned, after having ground a few coffee doses,
clean the inner surface of the funnel with a dry brush.
•
OPERATING RANGE OF THE MOTOR
IN THE VERSIONS WITH SINGLE-PHASE MOTORS, OBSERVE THE DUTY CYCLE
STATED IN THE LABEL LOCATED ON THE SIDE OF THE APPLIANCE.
E. g. : a data on the label 35s ON / 45s OFF points out an allowed duty cycle of 35 seconds
switched on and 45 seconds switched off.
APPLIANCES WITH THREE-PHASE MOTORS ARE ALLOWED FOR CONTINUOUS
WORKING.
In order to achieve good grinding, it is nonetheless recommended to operate the appliance at
intervals, allowing it to operate for no more than 10-15 minutes at a time.
10) SAFETY DEVICES
10) SAFETY DEVICES
10) SAFETY DEVICES
10) SAFETY DEVICES
THERMAL OVERLOAD PROTECTION
THERMAL OVERLOAD PROTECTION
THERMAL OVERLOAD PROTECTION
THERMAL OVERLOAD PROTECTION
The appliance’s motor is protected against overheating resulting from overcurrents by a thermal
overload protection which, when tripped, cuts off the power supply to the motor. Should the
protection trip as a result of anomalous operation, such as the grinding blades jamming, the
appliance must be turned off using the on-off switch, UNPLUGGED FROM THE MAINS, AND
SKILLED TECHNICAL PERSONNEL CONTACTED. NEVER PERFORM ANY WORK ON
THE APPLIANCE WHILE IT IS ATTACHED TO THE MAINS, TO AVOID THE RISK THAT
MOTOR TURNS ON SUDDENLY. If the appliance overheats as a result of the motor stopping,
allow the appliance to cool down before performing any repair work.
SAFETY SCREWS
SAFETY SCREWS
SAFETY SCREWS
SAFETY SCREWS
The hopper must always be attached to the upper grinding
The hopper must always be attached to the upper grinding
The hopper must always be attached to the upper grinding
The hopper must always be attached to the upper grinding
blade holder using the relevant screw, which must not be
blade holder using the relevant screw, which must not be
blade holder using the relevant screw, which must not be
blade holder using the relevant screw, which must not be
removed by the user under any circumstances.
removed by the user under any circumstances.
removed by the user under any circumstances.
removed by the user under any circumstances.
In order to prevent the adjustment disk from being removed -
which would make the rotating parts accessible - there is a
safety screw on the actual disk: said screw must be positioned
in whichever of the two holes on the disk enables the wider
and most suitable range of grinding adjustment, and must not be removed by the user under
any circumstances.
COFFEE OUTLET GUARD
COFFEE OUTLET GUARD
COFFEE OUTLET GUARD
COFFEE OUTLET GUARD
The coffee outlet guard must always be fixed to the doser (Grinder-Dosers), or to the funnel
(Electronic Grinder-Dosers), using the relevant screws, which must never be removed by the
user. THE REMOVAL OF THE COFFEE OUTLET GUARD CAN BE DONE BY SKILLED
TECHNICAL PERSONNEL ONLY AFTER DISCONNECTING THE APPLIANCE FROM THE
POWER SUPPLY BY UNPLUGGING.
Before reconnecting the appliance to the power supply, fix the safety device to the doser, or to
the funnel, by relevant screws.
9999
DISK SAFETY SCREW
ALTERNATIVE
THREADED HOLE
HOPPER SAFETY SCREW
COFFEE OUTLET GUARD
