4
Car-navigation unit Installation
1. Connect the USB, GPS antenna, and +B/ACC connectors to
the car-navigation unit.
2. Install the wiring harness clip.
3. Press the clips (4 locations) shown in the figure and install the
car-navigation unit to the lower panel.
1. Connect the negative battery cable and perform an operation check by referring to the owner’s manual
applicable to the vehicle.
2. If there is any malfunction, disconnect the negative battery cable and verify that each connector is properly
connected and the wiring harnesses are not damaged or pinched, then perform the operation check again. If it
does not operate normally, contact the dealer where the unit was purchased.
■
After installing the car-navigation unit, verify the connections of the GPS antenna, +B/ACC, and USB
connectors using the following procedure:
Connection verification of GPS antenna connector
1.
Turn the ignition switch to the ON position.
2. After the opening screen ends, the Audio off screen is
displayed.
•
Be careful not to press the car-navigation unit when
installing it.
CAUTION
Harness clip
USB
connector
+B/ACC
connector
GPS antenna
connector
Car-navigation unit
5. OPERATION CHECK
Audio off screen
Car-navigation unit
Lower panel
Clips
Clips
