─６─
12. With the drill bit pointed perpendicular to the body, drill 3 mm holes
in the drill mark positions (12 locations).
13. Expand the 3 mm holes (12 locations) to 10 mm using the drill.
14. Remove any burrs around the drilled hole with a round file.
15. Apply sufficient sealant to prevent rust.
16. After the sealant has dried, apply touch-up paint.
Side under spoiler installation
1. Use a soft cloth dampened with IPA (isopropyl alcohol) to clean the
surface of the vehicle where the side under spoiler is to be installed.
2. Install the 12 clips (small) and 3 clips (small) to the side under
spoiler.
•
Do not insert the clips completely into the slots. Insert them
only up to the center of the installation holes. The side under
spoiler cannot be installed if the clips are inserted completely
into the slots.
•
Install the clips (large) in the direction shown in the figure.
CAUTION
•
The drill bit is hot after drilling; be careful not to burn yourself.
CAUTION
•
Make sure anti-rust protection is carried out properly.
CAUTION
•
Make sure to remove burrs from the surface so that the body
surface is smooth.
CAUTION
Side under spoiler installation surface
Vehicle front
Hole for clip (small)
＜
Cross-section view
＞
3 mm
→
10 mm
Body
90°
Round
file
Drill hole
Burr
Touch-up
paint
Vehicle
front
12 clips (small)
Installation hole cente
r
3 clips (large)
Installation hole center
＜
Upper
surface view
＞
＜
Upper surface view
＞
